![]() ![]() Click the Trust this computer toggle to disable the setting.Connect your drive to the trusted computer.To remove trusted computer status from a computer: At the prompt, enter your password and click Continue.Click the Trust this computer toggle to enable the setting.On the Seagate Secure screen, click Trusted Computer.If your connected drive is already unlocked, do the following: On the Seagate Secure screen, click Unlock.If the prompt doesn’t appear automatically when you connect the drive: Check the Trust this computer checkbox.Remember, the password you created is case-sensitive, meaning that it distinguishes between upper-case and lower-case letters. At the prompt, enter the password you created when you enabled security.Connect your drive to a computer installed with Toolkit.You'll still need a password to unlock the drive when connected to other computers. Use this setting only on a computer that no one else uses. You can configure Toolkit to automatically unlock a drive when it's connected to a computer that you've designated as "trusted". (optional) Click the Trusted computer checkbox configure Toolkit to automatically unlock a drive when it's connected to a trusted computer.(optional) You can create a password hint, which you can view later in the event you forget your password again.On the Password Reset screen, enter your new password, and then enter the same new password in the field below it to confirm.At the prompt, enter your Seagate/LaCie account information and click Sign In.Note for LaCie Rugged Secure and Rugged RAID Shuttle drives - the sticker is located under the protective bumper. You can also find the PSID on a sticker on the hard drive. (Toolkit will automatically change lower-case letters to upper-case.) ![]() This is the 32-character reset code listed on the insert that was included in your device packaging.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |